Using The Show Port Command - 3Com 2103R-CSDI Installation Manual

4-6 C 4: M
HAPTER ONITORING
Using the SHOW
PORT Command
E R M
DGE OUTER ODULE
The SHOW PORT command displays information about a single port or all
ports.
The syntax for the SHOW PORT command is:
SHOW PORT slot.port {verbose}
The following command displays verbose information for port 1 on an
Edge Router module installed in slot 1 of an ONcore hub:
ONcore> show port 1.1 verbose
Port Display for Module 6102M-SDEK:
Port Mode Status
----- ------ -------
01.01 LOGICAL OKAY
Port Connector:
IP Address:
Subnetwork Mask:
Station Address:
Dip Network Setting:
The following command displays verbose information for port 1 on an
Edge Router module installed in slot 4 of an ONline hub:
ONline> show port 4.1 verbose
Port Display for Module 5103R-CSD:
Port Mode Status Network
----- --------
04.01 LOGICAL OKAY
Port Connector:
IP Address:
Station Address:
Capabilities:
Native Port Number:
O
PERATION
{no_verbose}
Network General Information
------- ----------------
ETHERNET_4 2103R-CSDI
------ --------
ETHERNET_1
BACKPLANE
2.0.0.2
ff.00.00.00
00-00-0c-c0-3d-63
ETHERNET_4
General Information
----------------
BACKPLANE
151.104.15.39
-NONE-
0