Saving The Configuration; Showing Module Configurations; Show Module Command; Show Port Command - 3Com CoreBuilder 5000 User Manual

Saving the
Configuration
Showing Module
Configurations
Show Module
Command

Show Port Command

After you make configuration changes to a module and ports, you
must issue the SAVE MODULE_PORT command to save the new
settings.
Failure to save module settings may result in loss of configuration data.
You can display status information about the 24-Port module using the
following network management commands:
SHOW MODULE
SHOW MODULE VERBOSE
SHOW PORT
SHOW PORT VERBOSE.
These commands are explained in the following sections.
The SHOW MODULE command enables users to display both brief and
verbose information about a particular module. Use the following
syntax to implement the command:
SHOW MODULE {slot.subslot} {verbose}
{ slot. all}
The following output is an example of the SHOW MODULE VERBOSE
command issued for a 24-Port module installed in slot 10:
CB5000> show module 10.1 verbose
Slot Module
----- ------- ------------- ------------- -----------------
10.01 6124M-TPL6
6124M-TPL6: CB5000 Ethernet 24-PORT 10BASE-T Module
Non-Volatile DIP Setting:
The SHOW PORT command enables users to display brief and verbose
information on both individual ports and all ports collectively. Use the
following syntax to implement the command:
{no_verbose}
Version Network
v1.00 PER_PORT
ENABLED

Saving the Configuration

General Information
3-17