Using The Show Module Command - 3Com 2103R-CSDI Installation Manual

4-4 C 4: M
HAPTER ONITORING
Using the SHOW
MODULE Command
E R M
DGE OUTER ODULE
The SHOW MODULE command displays information about a specific
module.
The syntax for the SHOW MODULE command is:
SHOW MODULE slot
The following command displays verbose information for an Edge Router
module installed in slot 1 of an ONcore hub:
ONcore> show module 1.1 verbose
Slot Module
----- ---------
01.01 6102M-SDEK v1.00
6102M-SDEK: ONcore ONdeck Ethernet Carrier Module
Boot Version:
ENGINE 1 Model Number:
Description:
Expansion Module Model Number:
Native Software Version:
Native Boot Software Version:
IP Default Gateway:
Mailbox Version:
No. Backplane Ports:
No. Front Ports:
Engine Status: OKAY
NVRAM Dip Switch State:
Module Capabilities:
ENGINE 2 Model Number:
Description:
Expansion Module Model Number:
Native Software Version:
Native Boot Software Version:
IP Default Gateway:
Mailbox Version:
No. Backplane Ports:
No. Front Ports:
Engine Status:
NVRAM Dip Switch State:
Module Capabilities:
O
PERATION
{verbose}
{no_verbose}
Version Network
------- -------
PER_PORT
General Information
----------------
2103R-CSDI
v1.00
2103R-CSDI
Edge Rtr DIBMSW
v10.03
v4.14
0.0.0.0
0.00.0
1
2
DISABLED
MACCFG;IPCFG;
NOT INSTALLED
0.0.0.0
0.00.0
4
0
NOT INSTALLED
DISABLED
-NONE-