Using The Show Port Command - 3Com CoreBuilder 5000 User Manual

Using the Show Port
Command
Example:
CB5000> show port 7.all verbose
Port Display for Module 6218M-ATPP :
Port Mode
----- -------- --------------- --------------- ------------------
07.01 ENABLED
Port Alert Filter:
Port Connector:
DIP Network Setting:
Static Switch:
07.02 ENABLED
Port Alert Filter:
Port Connector:
DIP Network Setting:
Static Switch:
Port
----- -------- --------------- ---------------- -----------------
07.03 ENABLED
Port Alert Filter:
Port Connector:
DIP Network Setting:
Static Switch:
The SHOW PORT command enables you to display both brief and
verbose information on both individual ports and all ports collectively.
The command sequence is:
SHOW PORT { slot.port }
{ slot. all}
The following output is an example of the SHOW PORT ALL VERBOSE
command issued for a media module installed in slot 7 (only the output
for ports 1, 2, and 3 are shown):
Status
NO PHANTOM
NO PHANTOM
Mode Status
NO PHANTOM
Showing Module Configurations
{verbose}
{no_verbose}
Network General Information
TOKEN_RING_1 Port is down
DISABLED
RJ45S
ISOLATED_11
DISABLED
TOKEN_RING_1 Port is down
DISABLED
RJ45S
ISOLATED_11
DISABLED
Network General Information
TOKEN_RING_1 Port is down
DISABLED
RJ45S
ISOLATED_11
DISABLED
4-15