Using The Terminal To Configure The Edge Router Engine - 3Com 2103R-CSDI Installation Manual

Using the Terminal
to Configure the
Edge Router Engine
Console and auxiliary port specifications are provided in Table 3-2 and
Table 3-3, respectively.
Table 3-2 Console Port Information
Interface Connector
RS-232 8-pin mini-DIN
Table 3-3 Auxiliary Port Information
Interface Connector
RS-232 8-pin mini-DIN
Mini-DIN connector pinouts are provided in Appendix A.
The Edge Router module is shipped autoconfigured for connection to a
network running NetWare®. If you are not connected to a NetWare network,
you may see the following message:
The IPXNetwork for LocalPath ms_ethernet couldn't be
learned.
Ignore this message and continue with the appropriate configuration.
Edge Router engine documentation is included on the Cisco Systems
CD-ROM that is shipped with the Edge Router module.
Refer to the Cisco Router Products Configuration and Reference Guide for
information on configuring parameters for the Edge Router module.
Configuring the Edge Router Engine
Transmission
Type Protocol
DTE Asynchronous, 9600, 8-bit data,
1 stop bit, no parity, XON/XOFF
Transmission
Type Protocol
DTE Asynchronous or synchronous, 9600,
8-bit data, 1 stop bit, no parity,
XON/XOFF
3-11