Misfeed In The Saddle Stitch Finisher - Sharp LASER PRINTER Operation Manual

SADDLE STITCH FINISHER

Misfeed in the saddle stitch finisher

If a misfeed has occurred in the saddle stitch finisher during printing, remove the misfed paper following the procedure
below.
Pull the knob and slide the saddle stitch
1
finisher away from the main unit.
Remove the misfed paper from the main
2
unit.
If misfed paper is not found in step 1, open
3
the top cover.
Turn roller rotating knob B until the triangle
4
mark reaches the position indicated in the
illustration (only if a punch module is
installed as a peripheral unit).
Roller rotating
knob B
Remove the misfed paper.
5
5-24
Be careful not to tear the
misfed paper during
removal.
Close the top cover.
6
Open the front cover.
7
Turn roller rotating knob C until a blue
8
indication is seen (when the stapling
function has been used).
Roller rotating
knob B
Blue
Remove the misfed paper from the stapler
9
compiler (when the stapling function has
been used).
Open the saddle stitch section cover (when
10
the saddle stitch function has been used).
Be careful not to tear the
misfed paper during
removal.