SADDLE STITCH FINISHER
Misfeed in the saddle stitch finisher
When a misfeed occurs in the saddle stitch finisher, remove the misfed paper following the procedure below.
1
Unlatch the saddle stitch finisher and slide
it away from the main unit.
2
Remove the misfed paper from the main
unit.
3
If misfed paper is not found in step 1, open
the top cover.
While pulling and turning roller rotating
4
knob B, remove the misfed paper. (when
the punch unit is installed)
3-10
After
removing
the
misfed paper, open and
close the duplex bypass/
inverter to reset the jam
indicator. ("Misfeed in
the Fusing area" step 1
or 4 on page 2-20)
When the misfed paper
is removed by turning
roller rotating knob B,
remove it taking care not
to tear the paper.
Roller rotating knob B
5
Close the top cover.
6
If saddle stitching was selected, open the
front cover.
7
Turn roller rotating knob C as shown in the
illustration until the blue indication is
seen.
Roller rotating
knob C
Blue
8
Remove the misfed paper from the stapler
compiler.
9
Open the saddle stitch section cover.
Be careful not to tear the
misfed
paper
during
removal.