Devices; Part Of The Image Is Cut Off; Printing Takes Place On The Wrong Side Of The Paper; Problems Related To Peripheral Devices - Sharp MX-M850 User Manual

Problem
Part of the image is
cut off.
Printing takes place
on the wrong side of
the paper.

PROBLEMS RELATED TO PERIPHERAL DEVICES

Problem
The connected USB
device cannot be
used.
The finisher / saddle
unit / saddle stitch
finisher / inserter /
folding unit does not
operate.
Point to check
Has the correct paper size been set?
Was the original placed in the correct
position?
Is the paper loaded with the print side
facing in the correct direction?
Point to check
Is the USB device compatible with the
machine?
Is the connected USB device
recognized correctly?
Does a message appear indicating that
you need to remove paper from the
stapler compiler?
Is the [START] key ( ) indicator on
the operation panel turned off?
Does an error message appear?
Does the following message appear in
the touch panel?
"Call for service. Code:xx-xx* Please
check the power of the finisher."
*Letters and numbers appear in xx-xx.
Have functions been disabled by the
administrator?
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
☞
PAPER TRAY SETTINGS
If you are using the document glass, be sure to place
the original in the far left corner of the document glass.
☞
PLACING ORIGINALS IN THE AUTOMATIC
DOCUMENT FEEDER
• Trays 1 to 4:
Load the paper with the front side facing down.
• Bypass tray and tray 5, 6 and 7:
Load the paper with the front side facing up.
Ask your dealer if the device is compatible with the
machine.
Use "USB-Device Check" in the system settings to
check whether or not the device can be recognized.
☞
USB-DEVICE CHECK
If it is not recognized, connect it once again.
Remove all remaining paper from the stapler compiler.
Configure the settings of punching or stapling on the
operation panel. For more information, see
FINISHING MODE" (page 65)
When the operation does not take place due to the
problem such as paper misfeeds, you will be informed
by the operation panel.
Check peripheral devices and the power plug. Remove
and then firmly reinsert the power plug, and restart the
machine.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
93
Solution
(page 80)
(page 53)
Solution
(page 84)
"MANUAL