Sharp LASER PRINTER Operation Manual page 141

Erase
The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it's initial setting.
Original
1
Touch the [ERASE] key on the SPECIAL MODES
screen.
ERASE
JOB BUILD
2 Select the desired erase mode.
ERASE
EDGE CENTER EDGE+CENTER
ERASE ERASE ERASE
3
Adjust the amount of erase and touch the [OK]
key.
CANCEL OK
EDGE
(0 1)
1 / 2
inch
Copy
The erase setting screen
will appear.
Select one of the three
erase modes. The selected
key will be highlighted.
Use the and keys to
adjust the erase width and
then touch the [OK] key.
Edge erase
Eliminates shadow lines around the edges of copies
caused when thick paper or a book is used as an original.
Center erase
Eliminates shadow lines produced by the bindings of
bound documents.
Edge + center erase
Eliminates shadow lines around the edges of copies and
eliminates the shadow at the center of copies.
4
Touch the [OK] key on the special modes screen.
After adjusting the exposure, follow any of the
copying procedures.
To cancel the erase function, touch the [CANCEL] key on
the erase setting screen.
SPECIAL FUNCTIONS
21