Recalling A Job Program; Deleting A Stored Job Program - Sharp LASER PRINTER Operation Manual

Recalling a job program

1 Press the [#/P] key.
2
Touch the desired storage register number key
to recall the job from memory.
JOB PROGRAMS
PRESS PROGRAM NUMBER.
1 2 3
6 7 8
RECALL
3
Set the number of copies as needed and press
the [START] key.

Deleting a stored job program

1
Follow steps 1 and 2 in "Storing a job program"
on the previous page.
2
Select a storage register number of the program
to be deleted.
EXIT
3 4 5
8 9 10
STORE / DELETE
When a number key is
touched, the selection
screen will be closed and
the stored job program will
be recalled. A number for
which no job program has
been stored cannot be
selected.
Copying will start with the
settings of the recalled job
program.
If a number key for which
no job program has been
stored is selected, the
screen will change to the
screen of step 4 on the
previous page (for storing
a program). The message
"TO STORE, SELECT AND
PRESS [OK]. TO DELETE,
PRESS [CANCEL]." will
appear. When [CANCEL] is
pressed, the screen will
return to the selection
screen shown to the left.
3
Touch the [DELETE] key.
A JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
CANCEL DELETE STORE
REC LL STORE/DELETE
JOB PROGRAM MEMORY
When the [DELETE] key is
touched, the screen in step
2 will return and the
program will be deleted. If
the [CANCEL] key is
touched, the screen in step
2 will return but the program
will not be deleted. If no
other programs are to be
deleted, touch the [EXIT]
key on the screen displayed
in step 2 to exit the job
program mode.
27