Using the key operator programs
Use the following procedure to use the key operator programs.
NOTE
When using the key operator programs for the first time, register a key operator code number (password required for using
the key operator programs). (See steps 3 and 5 below or see steps 3 and 5 on page 7-5.)
❇ When using the operation panel with touch panel, see page xxxx.
When using the operation panel on the main unit:
1
Press the [MENU] key.
KEY OPERATOR PROGRAMS
2
Press the [OK] key.
KEY OPERATOR CODE
O
3
Enter the fifth digit of the password and press
the [OK] key.
KEY OPERATOR CODE
O
If you press the [OK] key to
register the fifth digit after
entering it using the
or
key
on the operation panel, "0" will
appear at the fourth digit. If you
press the [BACK/C] key, you can
correct the entered number.
Press the [MENU] key
repeatedly
until
the
message
"KEY
OPERATOR PROGRAMS"
appears.
If the [OK] key is pressed,
the message shown to the
left will appear.
For the factory default
setting of the key operator
code number (password),
see page xxxx.
KEY OPERATOR PROGRAMS
4
Use the same procedure as step 3 to enter the
password from the fourth digit to the first digit
and then press the [OK] key.
KEY OPERATOR CODE
O
Use the same procedure as
above (fifth digit) to enter the
fourth digit to the first digit.
5
Press the [ ] or [ ] key to select the desired
program and press the [OK] key.
6
Press the [ ] or [ ] key to select the desired
item.
To exit the program, press the [MENU] key.
7
<Example>
For registration of a key
operator code number,
select "KEY OPERATOR
CODE CHANGE" and
6
press the [OK] key.
For settings of each
program, see the details of
classification of setting
items
(hierarchical
structure)
and
supplementary explanation
of key operation on and
after page xxxx.
6-3