10. Repeat steps 1 through 9 to register Handset 2.
11. Change the DIP Switches on the Base Unit to normal mode:
DIP SWITCH‐1 to OFF (up)
DIP SWITCH‐2 to OFF (up)
DIP SWITCH ‐ 3 to OFF (up)
Note: The LED on the base will flash normally when the unit returns to normal mode.
Note: It is recommended that you disconnect line 1 from the rear of the Base Unit and then
reattach after setting the DIP switches to the OFF position.
Page 6-8
System Registration and Deregistration
Need help?
Do you have a question about the Emerald ICE and is the answer not in the manual?