Table of Contents
Advertisement
Web Admin User Manual
After configuration is finished, click Apply button to save the setting. If you click Default
button, the entire configuration will be reset to the original values.
5.4.
DI (Sensor Input) / DO (Alarm Output)
Select DI/DO from Device Configuration menu to configure Sensor Input and Alarm Output.
After the setting up, select DI Status/DO Control on Device Configuration menu to configure
the behavior of those Input and Output ports.
DI/DO functionality can be set to either Normal Open or Normal Closed type as follows.
• Normal Open Type: Normal is OPEN, and goes CLOSED when triggered by an event.
Note: Make sure the type of the sensor and use it correctly to the type. If a
Sensor Input is not used, it must be set to Normal Open Type to avoid a
false input.
• Normal Close Type: Normal is CLOSED, and goes OPEN when triggered by an event.
DI/DO Setup
DI/DO Control
- 41 -
Advertisement
Table of Contents
