Table of Contents
Advertisement
Web Admin User Manual
7.
Recording Configuration
7.1.
SD Configuration
If a SD card is not present in the slot already, turn off the Network Camera before inserting a
SD card. Make sure to turn the power on after inserting the SD card. Open a web browser, type
in the IP address of the network camera. Log in as admin, and run Recording Configuration.
Note: Be sure to turn off the device before installing a SD card. Otherwise, the
SD card may become defective. Always check the recommended type of
SD card because non-conforming SD cards can cause abnormal behavior
of the system.
Enter Recording Configuration menu, then click the SD Information to find out the SD card's
format information.
If entire SD Information is shown as -None-, that means the SD card is not formatted. In that
case, click the Back button followed by clicking SD Status & Format.
- 59 -
Advertisement
Table of Contents
