Table of Contents
Advertisement
Web Admin User Manual
Category
Always
Schedule Only
Select
Event Only
Mode
Schedule and Event
Week
Schedule
Time
Date
Alarm Sensor
Event
Motion Detection
Camera Connected
Camera
Disconnected
Below is an example of configuring the recording condition, which means "
Alarm is activated or Motion is detected, on Saturday and Sunday every week
is not specified, it is taken as setting 24 hours. If date is not specified, it is taken as setting all
the months and weeks. Click the Back button if you want to return to previous page without
saving. Click the Save button to save the change and return to previous page.
Item
Recording is enabled all the time.
Recording is done by configured schedule.
Recording is controlled by configured event.
Recording is controlled by both schedule and
event.
Set day of week
Set time
Set date
Each of 1, 2, 3, 4 refers to the sensor number, and
checked when Event-Driven Recording is selected.
If all the four sensors are checked together,
recording is enabled only when all four sensor are
activated.
Each of 1, 2, 3, 4 refers to the sensor number, and
checked when Motion Detection Recording is
selected.
If all the four sensors are checked together,
recording is enabled only when all four sensor are
activated.
When Hardware motion detection is used, you
should set the detection area in Camera & Motion
section.
Recording is enabled when camera signal is
detected.
Recording is enabled when camera signal is not
detected.
- 67 -
Description
Video is recorded if
." If time condition
Advertisement
Table of Contents
