Table of Contents
Advertisement
Web Admin User Manual
Multicast
Address
Multicast
Port
To use ONVIF protocol, RTP/RTSP must be enabled.
4.9.
SNMP Setup for Cameras
SNMP (Simple Network Management Protocol) is a protocol to monitor and configure network
status of a network device. SNMP V1 and V2 are supported over MIB2 standard, and few
functions are not supported.
SNMP Trap can function when SNMP V1/V2 is enabled.
SNMP V1/V2
Trap
Destination IP
Address
Trap
Community
Available
Traps
Address for multicast video transfer.
The multicast address 0.0.0.0 is for stopping multicast.
Port number for viewing the video with a multicast address
Enable: Start SNMP service
Disable: Stop SNMP service
Enable: Start SNMP Trap service
Disable: Stop SNMP Trap service
IP Address to receive SNMP Trap messages.
Key value used in SNMP Trap e.g.) public
Type of SNMP Trap message
1. Cold Start : When SNMP starts
2. Authentication Failure : When key value of SNMP query
- 28 -
Advertisement
Table of Contents
