Shutdown Sequences Detail - IBM Network Management Card User Manual

Shutdown sequences detail

This section describes the individual shutdown sequences in detail.
Shutdown initiated by the shutdown timer
After a user-defined backup time period (configured on the Shutdown Parameters
page), the shutdown of all servers is initiated, followed by the UPS shutdown
(depending on its configuration). The UPS restarts when utility power is restored
(depending on its configuration).
The network management card tracks the shutdown times required by the
configured equipment connected to the UPS. To protect all connected equipment,
the network management card uses the maximum required shutdown time for the
Shutdown Duration parameter.
Chapter 6. Shutdown criteria and sequence
71