IBM Network Management Card User Manual page 28

v Modify Network settings: Select this option to modify existing network
v Set Ethernet speed: Select this option to change the network speed. Restart the
3 : Set Login Password to Default
Select this option to return the password to the default (passw0rd). Wait until the
confirmation message is displayed.
After the confirmation message is displayed, you can access the network
management card by using the web interface with the default password, but you
must restart the network management card to save the new password.
4 : Return to Default Configuration
Select this option to restore the parameters to the default configuration (see
"Network management card default parameters" on page 7). Wait until the
confirmation message is displayed. Restart the card to save the default parameters.
18
Network Management Card : User's Guide
parameters. Restart the network management card to activate the new
parameters. In DHCP mode, the network management card can receive the
following parameters according to the DHCP server settings:
– IP address
– Subnet mask
– Gateway address
Note: You cannot configure the IPv6 address through the serial connection. The
IPv6 address is provided by the network management card or by the IPv6
router (if an IPv6 router is available on the network). To enable the IPv6
feature and configure IPv6 settings, see "Network settings" on page 38.
For each of the following questions, you can press <Return> to select the
value shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N]
Static IP address [166.99.18.129]?
Subnet Mask IP address [255.255.248.0]?
Gateway address IP address [166.99.17.1]?
Wait during your new configuration is saved ...
Reset the card to take into account the new configuration.
network management card to activate the new parameters.
Set the Ethernet speed : [1 : Automatic, 2 : 10 MBit]
1
New Ethernet speed : Automatic
Wait during the new setting is saved ...
Reset the card to take into account the new configuration.