IBM Network Management Card User Manual page 73

2. Connect the Category 5 Ethernet cable that comes with the environmental
monitoring probe to the settings/sensor connector on the network management
card and to the RJ-45 connector on the environmental monitoring probe.
Note: If the cable is not long enough for your configuration, you can use a
cable that is 20 m (65.6 ft) or less.
3. Make sure that the uninterruptible power supply (UPS) has a network
connection, the power cord is connected, and the power to the UPS is turned
on. The environmental monitoring probe is automatically recognized by the
UPS.
4. Start a web browser and connect to the network management card IP address.
After the environmental monitoring probe is connected to the network management
card, an Environment menu option is available on the main menu. The
Environment menu has the following elements:
v Status
v Settings
v Log
Note: To switch the settings/sensor connector to the configuration mode,
disconnect the cable and reset the network management card.
Chapter 5. Connecting and configuring an IBM Environmental Monitoring Probe (optional)
63