Email Message Settings - IBM Network Management Card User Manual

accessible. If you click Show/Hide Events, all the events are displayed or hidden.
By default, only two events are selected for notification: UPS Off sequence in
progress and UPS alarms. You can click other events to select them, and you
restore the default selections by clicking Set Default.
Note: For security, you must click Save and enter the administrator login and

Email message settings

Use the Email Message Settings page to customize the content of email messages
that are initiated by the network management card (see "Email notification" on page
35).
All email message recipients have the following common settings:
v Sender: The source of the message. This field allows free text. However,
v Subject: The subject of the email message. Enter text and select from the
v
password to save modifications or run commands. The default login is
USERID (all uppercase), and the password is passw0rd (all lowercase with a
zero, not the letter O).
depending on the SMTP server configuration, the server might verify that the
domain name in the sender address exists and that the user in the sender
address belongs to that domain. The limit is 59 characters. The default is
ups@domain.com.
following optional check boxes to build the message subject:
– UPS Name is the name of the UPS.
– UPS Location is the geographic location of the UPS (see "System Settings"
on page 52).
– Event message is the event that generated the email message.
Message text: Type your message in this field. The limit is 255 characters.
As shown in the following figure, the body of the email message contains the
following items:
– Message text
– The date and time of the event, as saved in the log
Chapter 3. Using the network management card web interface
37