System Commands - IBM Network Management Card User Manual

Trap receiver commands
Use the trap receiver commands in the following table to configure the stations
receiving traps. The maximum number of trap receivers is three.
Table 31. Trap receiver commands
getTrap Read a trap receiver setting.
Syntax getTrap N [option1] [option2]
Options for HostName | Name | TrapCommunity | TrapSnmpVersion | TrapSelectedMibs
N = 0 | 1 | 2
Example #> getTrap 1 HostName Name
setTrap Modify a trap receiver setting.
Syntax setTrap N [option1] [option2]
Options for HostName = "xx..xx"
N = 0 | 1 | 2 Name = "xx..xx"
TrapCommunity = "xx..xx"
TrapSnmpVersion = Disabled | V1 | V3 | V1V3
TrapSelectedMibs = 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7
Example #> setTrap 0 Name="My application"
Comments Note 1:
bit0 = 1: MIB Pulsar enabled
bit1 = 1: Power MIB enabled
bit2 = 1: MIB IETF enabled

System commands

Use the system commands in the following table to customize the information about
the UPS.
Table 32. System commands
getSystem Read a system setting.
Syntax getSystem [option1] [option2]
Options Contact | Location | upsCustomName | Language
Example #> getSystem Location
setSystem Modify a system setting.
Syntax setSystem [option1] [option2]
Options Contact = "xx..xx"
Location = "xx..xx"
upsCustomName = "xx..xx"
Language = AUTO | FRE | ENG | SPA | GER | ITA | CHI | JPN | KOR |
CZI | RUS
Example #> setSystem Location="my office"
getHistSyst Read a history system setting.
Syntax getHistSyst [option]
Options Interval
Example #> getHistSyst Interval
56
Network Management Card : User's Guide
(See Note 1)