IBM Network Management Card User Manual page 46

On the Email Notification page, you can configure up to four recipients in the
Recipient list to receive email messages that are initiated by the network
management card. Each recipient receives an email message according to specific
trigger events, which you can select from the right side of the page. The network
management card log also indicates email transmission errors.
Set the following parameters for each recipient:
v Recipient: Specify the email address of the person or department that is to
v Attached files: Select the files (Measurements, Event Log, and System Log) that
v Periodic report: In addition to the email messages that are sent when events
v Email Message Settings: Click this link to display the Email Message Settings
v Network Settings: Click this link to display the Network Settings page (see
v Test: Use this to send an email message to the recipient immediately. Use this
v Save: Save your settings.
The right side of the page shows the events that can require notification. By default,
only main events, such as battery operation and a few of the UPS alarms, are
36
Network Management Card : User's Guide
receive the email. The limit is 99 characters. The default is
recipientn@domain.com.
you want to be attached to the email message. Data is sent in CSV format.
occur, you can schedule periodic email messages with the logs attached to be
sent to the recipient at specified intervals. To configure periodic email messages,
specify the day and time of the first transmission and the frequency of
subsequent transmissions. After the first transmission, the day and time of the
next transmission is displayed.
page (see "Email message settings" on page 37).
"Network settings" on page 38).
method to check email transmission, particularly to check access to the SMTP
server that is configured on the Network Settings page (see "Network settings"
on page 38). A transmission report is added to the system log. The event label in
the subject and text of the message is replaced with a test label. If you make any
modifications to the page, you must save them before you use the Test function.