IBM Network Management Card User Manual page 69

Table 35. Date and time commands (continued)
Syntax setDate [option1] [option2]
Options Date = yyyy/mm/dd
Time = hh:mm:ss
TimeSync = MANUAL | AUTO | NTP
TimeNtp = "xx..xx"
TimeZone = +/-hh:mm
TimeDaylight = 0 | 1
Example #> getDate timeSync=MANUAL
Comments Note 1: Setting is write-enabled depending on "TimeSync" status.
Note 2: Setting resolves to the nearest half hour. For example, sending +02:36 results in +02:30, and
sending +02:46 results in +03:00.
Environment commands
Use the environment commands in the following table to configure the optional
environmental monitoring probe.
Table 36. Environment commands
getEnv Read an environment setting.
Syntax getEnv [option]
Options Name
Example #> getEnv Name
setEnv Modify an environment setting.
Syntax setEnv [option]
Options Name = "xx..xx"
Example #> setEnv Name="sensor"
getTemp Read a temperature setting.
Syntax getTemp [option1] [option2]
Options Unit | HighThreshold | LowThreshold | Hysteresis | Offset | HighNotify | LowNotify | HighShutdown |
LowShutdown
Example #> getTemp Unit
setTemp Modify a temperature setting.
Syntax setTemp [option1] [option2]
Options Unit = C | K
HighThreshold = xx
LowThreshold = xx
Hysteresis = xx
Offset = xx
HighNotify = 0 | 1
LowNotify = 0 | 1
HighShutdown = 0 | 1
LowShutdown = 0 | 1
Example #> setTemp Unit=C
Comments Note 1: Setting is write-enabled only if the notification is enabled.
(See Note 1)
(See Note 1)
(See Note 2)
(0=No, 1=Yes)
(0 to 5)
(-5 to 5)
(0=No, 1=Yes)
(0=No, 1=Yes)
(0=No, 1=Yes)
(0=No, 1=Yes)
Chapter 4. Using the Telnet, SSH, and CLI
(See Note 1)
(See Note 1)
59