Ups Weekly Schedule Programming - IBM Network Management Card User Manual

UPS weekly schedule programming

Note: The UPS configuration might prevent the shutdown and restart commands
Click Weekly Schedule from the menu to set up the timing of specific weekly
actions.
You can use the weekly schedule to optimize power consumption or program a
restart of the protected equipment at a set time.
In a shutdown sequence, the IBM UPS Manager software is notified to make sure
that each device is shut down correctly before the UPS output is turned off. You can
program up to seven UPS shutdown sequences in one week, with a minimum
shutdown delay of 30 minutes.
The on/off sequences are valid only if the network management card time is set
correctly.
Note: For security, you must click Save and enter the administrator login and
30
Network Management Card : User's Guide
from running correctly. For more information, see the Installation and
Maintenance Guide that comes with the UPS.
password to save modifications or run commands. The default login is
USERID (all uppercase), and the password is passw0rd (all lowercase with a
zero, not the letter O).