Environment Status - IBM Network Management Card User Manual

Environment status

Click Status to display the Environment Status page.
For both the temperature and humidity measurements, a graduated gauge provides
the following functions:
v The cursor indicates the current value.
v Two red zones to the left and right represent the high and low thresholds that
v You can set an alarm to notify you if the measured value enters one of the red
v Time stamped minimum and maximum temperatures show the extreme values
v You can force the minimum and maximum values to the current value at any time
v The environmental monitoring probe is factory-calibrated, but you can apply an
v Input #1 and Input #2 show the positions of the two contacts that are acquired
v The last status change of each contact is time stamped.
The Internet browser updates the Environment Status page every 10 seconds.
64
Network Management Card : User's Guide
you can set on the Environment Settings page.
zones (see the Notification parameter on the Environment Settings page).
that have been recorded since the last time you clicked Reset Min/Max. A thin
dotted line shows their positions on the gauge.
by clicking Reset Min/Max.
offset to adjust the measurement by clicking Calibrate.
by the environmental monitoring probe. The positions are displayed with the
parameters entered on the Environment Settings page.