Table Of System Alarms - IBM Network Management Card User Manual

Table 40. UPS events (continued)
Alarm on
Positive dc bus too low
Protection lost
Redundancy lost
Normal ac NOK
Low battery
UPS communication failed
UPS database not available
UPS on battery
Emergency button on
Fan fault
Load not powered
UPS internal fault
Battery fault
UPS overload
UPS overtemperature
Imminent UPS shutoff
sensor_name: Temperature is above high threshold xx°C
sensor_name: Humidity is above high threshold xx%
sensor_name: Temperature is below low threshold xx°C
sensor_name: Humidity is below low threshold xx%

Table of system alarms

The following table lists the system alarms.
Table 41. System alarms
Network Management Card startup
Send test mail SUCCESS
Send test mail ERROR
Send mail to recipient ERROR
sensor_name Communication failure
sensor_name Communication restored
Firmware upgraded
Connected NSM list Full, last connection refused
sendTrap()-> Unable to resolve hostname hostname
SNMP Send Trap # num failure to hostname
Time changed by user with yyyy/mm/dd hh:mm:ss
Time synchronized by NSM or EPM with yyyy/mm/dd hh:mm:ss
78
Network Management Card : User's Guide
Alarm off
Positive dc bus OK
Protection OK
Redundancy OK
Normal ac OK
Battery OK
UPS communication restored
UPS database OK
UPS on normal ac
Emergency button off
Fan OK
Load powered
UPS OK
Battery OK
UPS returns to normal load
UPS temperature OK Imminent UPS shutoff UPS OK
UPS OK
sensor_name: Temperature is in normal range
sensor_name: Humidity is in normal range
sensor_name: Temperature is in normal range
sensor_name: Humidity is in normal range