Configuring The Network Management Card - IBM Network Management Card User Manual

Configuring the network management card

To configure the network management card, complete the following steps:
1. Make sure that the UPS is turned on.
2. (Optional) For advanced configuration through a web interface and to use the
network management card on a network, connect an Ethernet cable (purchased
separately) to the Ethernet connector on the network management card and to
your network. Wait approximately 2 minutes until the UPS data LED flashes
regularly, indicating normal operation. (See "LEDs and connectors" on page 6.)
Note: You will be able to set the network management card parameters through
the settings/sensor connector even if the network management card is
not connected to the network.
Chapter 2. Installing and configuring the network management card
11