IBM Network Management Card User Manual page 50

v IPv6 Gateway: If IPv6 Auto Config Enabled is selected, the IPv6 Gateway field
v IPv6 Local Address: The IPv6 local address is generated from the network
v IPv6 Address 2: If IPv6 Auto Config Enabled is selected, the second IPv6
v Firmware Upload: Select Enabled to authorize remote updating of the network
v Primary DNS Server (IPv4 or IPv6): The IP address of the main DNS server
v Secondary DNS Server: The IP address of the secondary DNS server that
v SMTP Server (for Email Notification): The name or IP address of the local
v SMTP server authentication: If you select this check box, enter the SMTP
Note: For security, you must click Save and enter the administrator login and
Restart the network management card after any changes to these parameters (see
"System settings" on page 41).
40
Network Management Card : User's Guide
If IPv6 Auto Config Enabled is not selected, you can enter the IPv6 network
prefix in the following format:
– [4-128] for an IP address 1:
[::1:0:0 ; 1FFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF]
– 64 for an IP address 1:
[2000:: ; FEFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF]
is not available.
If IPv6 Auto Config Enabled is not selected, you can enter the name of the IPv6
gateway.
management card MAC address and is displayed in this field.
address is provided by the DHCP server (for example,
1876:720:410:100A:1111:2222:33:4444) and cannot be changed.
If IPv6 Auto Config Enabled is not selected, the IPv6 Address 2 field is not
available.
management card embedded software. The default is Enabled.
that ensures conversion of the domain name to an IP address.
ensures conversion of the domain name to an IP address if the primary DNS
server is not available.
server to which the network management card connects to send email
messages. You can enter a host + domain name (DNS resolution) or an IP
address.
The default is smtpserver. The network management card uses the standard
port (25) for sending email messages.
server user name and password.
password to save modifications or run commands. The default login is
USERID (all uppercase), and the password is passw0rd (all lowercase with a
zero, not the letter O).