Ups Alarm - IBM Network Management Card User Manual

v Battery charge level: Remaining battery charge (in percent). The battery modes
v Remaining backup time: An estimate of the maximum backup time that remains
v Battery status: The result of the last automatic battery test that was run by the

UPS Alarm

Click UPS Alarm on the UPS Properties page to display the list of current alarms.
Table 25 on page 27 lists the alarm severity levels. For the managed UPS and
system alarms, see Table 39 on page 75 and Table 41 on page 78.
26
Network Management Card : User's Guide
Table 24. UPS output status
Element
(green)
(red)
are as follows:
– Fault: The battery is faulty.
– No battery: No battery is found.
– Charging: The utility power is present, and the battery charge is in progress.
– Discharging: The UPS is operating from the battery.
– Floating: The battery is at the optimal charge level.
– Resting: The battery is not charging.
Note: The battery has reached the end of the floating mode time period and
has stopped charging to extend the life of the battery. The battery
slowly discharges until the minimum charge level is reached. When the
minimum charge level is reached, the battery returns to Charging
mode.
– Charger disabled: The battery charger is off.
for the battery before the UPS shuts down.
UPS. The possible values are as follows:
– OK: The test was completed correctly.
– NOK: The battery must be checked.
– Deactivated: The automatic battery test is not validated on the UPS.
Description
Receptacle powered
Receptacle not powered or not protected