2
Select the interface or protocol ([TCP/IP], [Serial], [Centro], [VPI], [SNMP])
to be set up from the [System parameters] menu.
The setup selections will display in the right-hand pane of the window. In the
example below, [Serial] has been selected.
• Only standard features and installed options are listed in the [System
parameters] menu. [VPI] and/or [Centro] will be listed if one or both of
these options is installed.
• Refer to the section " Communication Parameters Definitions" in "3.1
Communication Parameters" for more information about the communication
parameter entries.
3
Set up each of the parameters as required, and then select the [Apply] button.