Xerox 6050 User Manual page 145

Descriptions of Area Mode
The area modes are described below.
ADAPTED
FIXED (HP-GL)
FIXED (HP-GL/2)
IP AREA
IW AREA
RASTER
FIRST
Fig.1. (ADAPTED)
Input image
(0,0)
Fig.2. (FIXED)
(+X1,+Y1)
Input image
(0,0)
The data range of the input image is set as the print range (see
Fig.1).
The range that encloses the maximum coordinate of the input
image and the coordinates that represent the starting point of that
coordinate is set as the print range.
The range that encloses the maximum coordinate of the input
image and a starting point of (0,0) is set as the print range
Fig.2).
The range specified with the [IP Command] is set as the print
range (see Fig.3).
The range specified with the [IW Command] is set as the print
range (see Fig.3).
The range that corresponds with the input size specified with the
[Destination Raster] command is set as the print range.
Only the first quadrant area is set as the print area (see Fig.4).
Images located in areas outside of the first quadrant area will not
be printed (see Fig.5).
Output image
Auto Layout: [YES]
Output image
Auto Layout: [YES]
(
see
Offset
Auto Layout: [NO]
Offset
Auto Layout: [NO]