Xerox 6050 User Manual page 91

TCP/IP Setup
PORT SETTING
TCP/IP
TCP/IP
Default Parser
Default Parser
HPGL
IP Address
100. 000. 000. 000
IP Address
120. 000. 000. 000
IP Address
123. 123. 123. 001
1
Display [TCP/IP] on the selection screen, and
then press the <
2
Select the item that is to be set up with the use of
the < > and < > keys, and then press the
<
[Ethernet Setting], [Default Parser], [IP
Address], [Mask Value], [E-Net Address],
[Dynamic Routing], and [Static Routing] will be
displayed in that order.
3
Select the parameters with the use of the < >
*
and < > keys, and then press the <Set> key.
An asterisk [*] will be displayed on the right
side of the parameters once they have been set.
Entering addresses
1. Move the cursor to the left and right with the
use of the <
2. Select the required value with the use of the
< > and < > keys. The value will increase
or decrease sequentially between 0 and 9.
3. Press the <Set> key once all values have been
*
entered.
> key.
> key.
• Additions can be made to the routing
table when [Static Routing] is enabled.
• The [E-Net Address] can only be
displayed, not changed.
> and < > keys.
• To proceed to the next menu, move the
cursor to the right-hand side and press
the < > key.
• To return to the previous menu, move
the cursor to the left-hand side and
press the < > key.