Table of Contents
Advertisement
Diagnostic and Configuration Utilities
The features and commands for the configuration utility for Windows Advanced
Server Limited Edition v 1.2 (LPutil64.exe) are similar to those of the Windows NT
and Windows 2000 configuration utility (lputilnt.exe). These differences will be
pointed out in this document where appropriate.
You can run the utility from the CD or copy and run it from your local hard drive.
NOTE: You must install and connect the SCSI Miniport driver to at least one drive before
LightPulse Utility/NT can operate properly. You can alternately set the registry parameter
Simulate Device= to 1.
View HBA Parameters
From the LightPulse Utility/NT Main menu screen:
1. Choose an HBA. On the menu bar, click on an HBA or pull down the category list.
2. Choose an option to view HBA parameters.
There are nine options available, each displaying a different group of HBA
parameters:
•
Adapter Revision Levels—View information about the chipset and firmware
revision levels of the selected HBA.
•
Firmware Maintenance—Maintain firmware revision levels of the selected
HBA.
•
Loop Map—View a list of the members of the selected HBA loop map.
•
PCI Registers—Maintain the values of the PCI configuration registers of the
selected HBA.
•
Configuration Data—Maintain information about the data in each of the
configuration regions in the flash ROM of the selected HBA.
•
Driver Parameters—Maintain information about device driver parameters that
are maintained in the Windows/NT registry.
•
Persistent Bindings—Maintain information about persistent bindings of the
selected HBA.
•
Link Statistics—Maintain statistics about the arbitrated loop of the selected
HBA.
•
Status and Counters—Maintain status and counters for bytes, frames,
sequences, exchanges, and so on.
5–6
host bus adapter for Windows and Linux installation guide
Advertisement
Table of Contents
