Add (Register) Card - EverFocus EFC301 User Manual

13.1.1 Add (Register) Card

In the card setting page, click the "Add" button, then the card adding dialog box pops up;
see the figure below:
Operation Procedures:
1) Input the card number in the textbox. In case of adding multiple cards with consecutive
numbers, check "Add Card in Batch," and then input the quantity of cards added in
batch. The input card number is the initial card number.
2) Set the attitudes of the card, including card validity, first card door open, protection
setup validity, anti‐passback validity, card validity period, password status, card scheme
selection and control group. Check the first card door open, protection setup validity,
password status and other attributes of the card; input password and duress password;
select card validity period; select the control group; and select the card scheme.
3) Allocate the card or multiple cards to one Cardholder. After inputting the employee
number, the name column will automatically display the Cardholder number; click to
select. In a similar way, the Cardholder number can be input first.
4) After selecting the attributes of the card, click the "Save" button, then the card will be
added to the card list.
Initial card number: Input the card's internal code. The three card types supported by the
controller include: Decimal, hexadecimal, and nnn‐nnnnn. Taking the 8‐digit decimal card
internal code as an example, add 0 in front of the internal code if the internal code is less
than eight digits.
The ID card internal code is in the form of Wiegang 26, i.e. 26 bits. Discarding the parity
check of the first bit and last bit, the remaining 24 bits are the true internal code of the card
after converting it to the decimal system.
 The user can read the card number through the printed on the card.
 The user can read the card number from the illegal card swiping record after swiping
the card on the card reader of the on‐line controller.
 The user can obtain the card number by adding the card to the system card reader of
the controller and downloading the card data of the controller.
For the cards with consecutive numbers, the cards can be added in batch by inputting the
initial card number and the card quantity.
NAV Series TCP/IP Standalone Network Access Controller
Figure 13-4 Add card
85