Table of Contents
Advertisement
For setting "minutes," input three digits in the range of 0‐999 and for setting "seconds,"
input two digits in the range of 0‐59. Press "#" to confirm and the setting will take effect.
Press "*" to exit and the setting will not take effect.
4.6.3 Door Access Mode
Scroll to "Door Access Mode" menu item and press "#" to enter the submenu.
Scroll to select the door open mode and press the numerical key "5" to select. The selected
item is marked with a "*". Then, press"*" or"#" to exit the current interface.
4.7 Alarm Setting
The EFC301 controller provides one alarm input circuit and one alarm output circuit. Users
can carry out detailed configurations through the user interface. Details will be introduced
below.
4.7.1 Composition of Alarm
The alarm input of the EFC301 controller can be connected with external alarm equipment
such as a PIR sensor, glass breakage sensor, etc and the alarm output can drive a 4A alarm
relay.
4.7.2 Basic Configuration of the Alarm
The EFC301 controller will record all events such as entry permit, entry prohibition, etc.
Some dangerous events are required to trigger alarm output, such as fire alarm input,
protection area alarm input, etc. Some events do not need alarm output, such as card
swiping operations at invalid times. Whether the alarm is required to be triggered will be
set according to the user's requirement. EFC301 collects all the event records that may
trigger alarm output and makes effective or ineffective alarm choices of these events.
All major events can be set to trigger alarms, such as alarm input signals, unknown cards,
expired cards, invalid cards, invalid door regions, invalid times, anti‐passback failure, wrong
password, wrong system password, wrong protection setup/withdrawal password, forced
door open, Door Over Time and remote alarm. The detailed setup method will be
introduced below.
4.7.3 Enter Alarm Setting Menu
In the "System Setting" main menu, scroll to "Alarm Setting" menu item and press "#" to
enter the submenu. The submenu of the "Alarm Setting" has "AlarmIN Setting" and "Alarm
Action Setting" submenu items for setting physical alarm input and alarm output time of
alarm events, respectively.
Follow schedule
*Card Only
Card + PIN
Card or PIN
NAV Series TCP/IP Standalone Network Access Controller
Normal Close
Normal Open
31
Advertisement
Table of Contents
