2 Installation; Installation Preparation; Obtain A Floor Plan - EverFocus EFC301 User Manual

NAV Series TCP/IP Standalone Network Access Controller
2 Installation
The Installation has three procedures described as below. Each procedure will be
introduced in the following sections in detail.
Step 1: Installation Preparation
 Obtain a floor plan
 Determine the hardware and location
 Determine the number of controllers according to
system structure
Step 3: Software Setup / Configuration
 Log in controller built‐in software through IE on computer
 Set user account for user software
 Set controller and other equipment
 Set holidays, shifts and door Access Rule
 Log in card and set card attributes

2.1 Installation Preparation

Before installation, users are advised to collect information properly which will make the
installation more smoothly and helps to reduce time and energy cost. For professional
constructors, the information below will be of great use.

2.1.1 Obtain a Floor Plan

Obtain a floor plan of the building in which the access control system is to be installed.
Obtaining a floor plan helps the installer determine what components need to be installed,
Step 2: Hardware Installation
 Installing the controller
 Connecting to the door lock / open button / sensor / bell
 Connecting to the alarm input / output
 Connecting to the card reader
 Connecting to the computer through the networkMount a
backup battery in the enclosure
6
Chapter
2