Hardware Setup 1 - Classe Audio Sigma Series Owner's Manual

hardware setup 1

2
3
4
Classé CAN-Bus Equipped Products
Two or more Classé CAN-Bus equipped products are required, at least one of
which must have a touchscreen display.
Category 5 Network Cables
These are ordinary network cables, commonly used for broadband Internet
connections. They should be typical "straight through" cables not the "crossed
over" type, and the total required will be one less than the total number of
CAN-Bus equipped components in your system.
CAN-Bus Terminator
A single CAN-Bus Terminator may be required. It is inserted into the
CAN-Bus OUT connector of the last component in the CAN-Bus
daisy chain. One is included in the box with your amplifier. They are also
available free of charge from your nearest Classé Customer Support Centre.
http://www.Classeaudio.com/support/service.htm
SSP-300 & 600 CAN-Bus Interface Box
Systems that include an SSP-600 or SSP-300 will also require an
SSP-300/600 CAN-Bus Interface Box. These are included with the products or
available free of charge from your nearest Classé Customer Support Centre.
http://www.Classeaudio.com/support/service.htm
17