Configuration Setup; Configuration Name; Configure Outputs - Classe Audio Sigma SSP Owner's Manual

Configuration Setup

The Configuration Setup page allows you to define up to six different speaker
configurations. Touch the button for the specific configuration you want to set
up to open its configuration setup menu. The page contains buttons for naming
the configuration and enabling balanced (XLR) and single-ended (RCA) outputs
for Front L&R, and independently enabling Center, Subwoofer, Surround and
Auxiliary outputs. Choosing a subwoofer output causes a Bass Management
button to appear. The same menu is used to set up each configuration.

Configuration Name

As with naming sources, press the Configuration Name button to access the
keyboard used for customizing the configuration name. Press Enter after making
your changes to save the new name.

Configure Outputs

Choose the output connectors you want enabled with this configuration. If
a subwoofer is used, a Bass Management button appears, allowing you to set
crossover frequency and slope.
If you also want to High-Pass Filter any of the main output channels, check the
box for HP Filter corresponding to the speaker group for which you want the
HP filter setting to apply. The crossover will pass the higher frequencies and
correctly direct the low frequencies to the subwoofer(s) based on your frequency
and slope settings. If this box is unchecked, the corresponding channels' signals
will pass full range.
37