Configuration Setup; Configuration Name; Configure Outputs - Classe Audio Delta PRE Owner's Manual

Configuration Setup

The Configuration Setup page allows you to define up to six different speaker
configurations. Touch the button for the specific configuration you want to set
up to open its configuration setup menu. The page contains buttons for naming
the configuration and enabling balanced (XLR) and/or single-ended (RCA)
outputs for Main, Aux and Subwoofer channels. Choosing a subwoofer output
causes a Bass Management button to appear. The same menu is used to set up
each configuration.

Configuration Name

As with naming sources, press the Configuration Name button to access the
keyboard used for customizing the configuration name. Remember to press Enter
after making your changes to save the new name.

Configure Outputs

Choose the output connectors you want enabled with this configuration. If a
subwoofer (or two) is used, a Bass Management button appears, allowing you to
set crossover frequency and slope, or enable stereo or two mono subwoofers.
If you also want to High-Pass Filter the L&R outputs, check the box for L/R
HP Filter. The crossover will pass the higher frequencies and correctly direct
the low frequencies to the subwoofer(s) based on your frequency and slope
settings. If this box is unchecked, L&R channel signals pass full range and the
lower frequencies are duplicated by the subwoofer(s). This may result in too
much bass, especially at certain frequencies, so equalization may be required to
compensate.
27