Table of Contents
Advertisement
A. Input module installation.
Up to 10 input modules can be inserted in any order in the RCVDS05.
Install the input modules in the RCVDS05 as follows :
1. Power down the RCVDS05 and disconnect the power cord from the wall outlet.
2. Slide the input module into a free slot in the board rack (rear of the RCVDS05).
Insure that the module is seated correctly in the guide grooves A.
3. Press the face of the input module until the module plug seats in the backplane
connector of the RCVDS05.
4. Secure the input module by tightening the retaining screws B on top and bottom.
16
INPUT MODULES
%
$
R5975765 RCVDS05 020997
Advertisement
Table of Contents
