Viii. Optional Decoder - Barco R9827880 Owner's Manual

VIII. OPTIONAL DECODER.

Order number : 98 28030
A decoder can be installed for Video, S-Video or Component Video decoding. All
signals are converted into RGB. The decoder must always be installed in the master
RCVDS05. So, in a multiple RCVDS05 installation, only one decoder has to be
installed.
Attention : When multiple RCVDS05's are used in the RS232 mode, every RCVDS
where decoder operations have to be done, must be equipped with such a decoder.
S-Video, Composite Video and Component Video with separate sync are converted
into RGBS analog.
Component video, with sync on Y is converted into RGsB .
Example : Two RCVDS05's linked in BARCO mode. Video source connected to the
second RCVDS05.
The video signals will be transported from the second RCVDS05 to the first
RCVDS05.
The first RCVDS05 will decode and convert the Video signals into RGBS. These
RGBS signals will be available on the output module of the first RCVDS05.
A. RCVDS05 with decoder, connected to a projector.
If the projector software is adapted to receive converted signals from a RCVDS05, the
decoder inside the RCVDS05 will always be used even when the projector itself is
equipped with a decoder.
B. RCVDS05 with decoder, used as stand alone switcher.
The decoder settings will be 'memorized' per input source in the master RCVDS05.
During an adjustment, the RCVDS05 will display a number between 0 and 99 for
saturation and hue (tint) and -3, 0, 3 or 6 for sharpness.
70
OPTIONAL DECODER
R5975765 RCVDS05 020997