Table of Contents
Advertisement
Image 2-19: Cables from the lower chassis and "Play/Pause" and "Stop" keys
1
"Play/Pause" and "Stop" keys
Motherboard installation
1.
Slide the lower edge of the motherboard under the lower chassis.
The lower edge has the 4-pin ATX12V1 and the CPUFAN1 connectors. The DIMMs should be on the left-hand
side of the CPU cooler.
2.
Align the motherboard carefully over the eight mounting posts, taking care not to slide the motherboard; this
can damage components on the back of the motherboard.
The three screw holes on the lower edge of the motherboard should be under the access holes in the support
bar that runs the width of the unit.
Image 2-20: Motherboard in position
1
Power supply
2
Motherboard
3
DIMMs
4
Motherboard screws (x8)
3.
Screw in the eight screws that secure the motherboard to the chassis.
Initial motherboard connections
The initial motherboard connections can be made before the rear I/O plate is installed.
1.
Refer to Image 2-21 and Image 2-22 for the positions of the motherboard headers for the initial motherboard
connections.
24-1701050-00 /01
EC-200 to EC-210 Conversion Kit
Conversion process
23
Advertisement
Table of Contents
