Rcvds05 As Stand Alone Switcher; Installing The Link - Barco R9827880 Owner's Manual

INSTALLATION
Plug the female D9 connector of a serial cable into the male connector of the serial
port of your computer.
All RS232 commands have to be sent to the projector. Only the comandfor the
projector can be used. These commands are described for CRT projector in the
manual "Projector Control Software", order number R9827530 and for LCD projec-
tors in the manual "RS232 communication protocol", order number R5975236.
A projector controlled via the RS232 link acts in the same way as a projector
controlled via the RCU (remote control) or via the key panel on the RCVDS05.
Selecting a source of the RCVDS05 with the RCU or via RS232 commands is the
same.
E.2. RCVDS05 as stand alone switcher.
The RCVDS05 has to be equipped with a communication interface module.
No IR remote receiver can be connected to the RCVDS05.
E.2.1. Installing the link.
Plug the male D9 connector of a communication cable (straight cable) into the female
D9 connector labelled "to host" on the face of the communication interface module
in the RCVDS05.
Plug the female D9 connector of the communication cable into the male connector
of the serial port of your computer.
The switch on the communication interface module has to be set in the position
"RS232".
42
R5975765 RCVDS05 020997