Rcvds05 To Audio Amplifier; Using Multiple Rcvds05'S As Source Selector For A Barco Projector; Signal Connection Between Multiple Rcvds05'S - Barco R9827880 Owner's Manual

Projection system
Table of Contents

Advertisement

B.2.2. RCVDS05 to AUDIO AMPLIFIER.
Connect the left and right audio outputs (connectors below the output module) of the
RCVDS05 to the left and right audio inputs of an audio amplifier using two conductor
audio cables with RCA (cinch) connectors.
B.3. Using multiple RCVDS05's as source selector for a
BARCO projector.
The communication link and signal connections between the first RCVDS05 (master
RCVDS) and the projector remain the same as for one RCVDS05.
A communication module must be installed in each RCVDS05, except in the last one
in the line.
B.3.1. Communication linking between multiple RCVDS05's.
Plug the female D9 connector of a data communication cable into the male D9
connector labelled "to next device" on the face of the RCVDS05 communication
interface module.
Plug the male D9 connector of the other end of the communication cable into the
female connector labelled "to projector" on the back plane of the second RCVDS05.
The position of the mode switch must be in the position "BARCO".
B.3.2. Signal connection between multiple RCVDS05's.
Each previous RCVDS05 in the link must be equipped with an expansion module.
Example : 4 RCVDS05's linked together, the first 3 RCVDS05's need an expansion
module.
The expansion module must be inserted in the last free slot of each RCVDS05 (all
input modules for this RCVDS must be on the left hand side of the expansion module).
Never insert an input module on the right hand side of the expansion module.
The signal transfer between two or more RCVDS05's happens on 5 coaxial cables
with BNC connectors.
Connect 5 cables between the BNC connectors of the expansion module of the first
RCVDS and the BNC connectors (R, G, B, H/C, V) of the output module of the second
RCVDS.
The output module of the second RCVDS can be :
- a standard output module
or
- a 5 cable output module (optional).
Connect an audio cable between the output connectors of the second RCVDS05 and
the audio connector below the expansion module of the first RCVDS05.
Connection diagram on next page.
32
INSTALLATION
R5975765 RCVDS05 020997

Advertisement

Table of Contents
loading

This manual is also suitable for:

R9827889R9827881R9827888Rcvds05s

Table of Contents