eth Commands
eth switch storm ifconfig
Configure per port storm control parameters.
SYNTAX:
eth switch storm ifconfig
where:
port
state
rate
burstsize
broadcast
multicast
unknown
E-DOC-CTC-20071119-0014 v1.0
port = <number{1-4}>
[state = <{enabled|disabled}]>
[rate = <{100|200|300|400}]>
[burstsize = <number{2-8}]>
[broadcast = <{enabled|disabled}]>
[multicast = <{enabled|disabled}]>
[unknown = <{enabled|disabled}]>
The port.
Enable/disable storm control.
Rate in 10ths of percent.
Burst size in KBytes.
Storm control for broadcast traffic.
Storm control for multicast traffic.
Storm control for traffic with unknown
destination address.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
323