Nat Mapadd - THOMSON TG576 v7 Reference Manual

nat mapadd

Add an address mapping to a nat enabled interface.
SYNTAX:
nat mapadd
where:
intf
type
outside_addr
inside_addr
access_list
foreign_addr
protocol
outside_port
inside_port
mode
weight
538
intf = <{loop|Internet|LocalNetwork}>
[type = <{napt|nat}]>
[outside_addr = <ip-range]>
[inside_addr = <ip-range]>
[access_list = <ip-range]>
[foreign_addr = <ip-range]>
[protocol = <{ah|egp|esp|ggp|gre|hmp|icmp|
igmp|pup|rdp|rsvp|tcp|udp|vines|xns-idp|6to4|
ipip} or number]>
[outside_port = <port-range]>
[inside_port = <port-range]>
[mode = <{auto|inbound|outbound}]>
[weight = <number{0-255}]>
The IP interface name.
The type of mapping.
The outside (typically public) IP address (range
for NAT).
The inside (typically private) IP address (range
for NAT).
The range of inside addresses the mapping is
restricted to.
The range of destination addresses the mapping
is restricted to.
The IP protocol.
The outside port number or range (only for
NAPT).
The inside port number or range (only for
NAPT).
The mode to create the portmap.
The weight for the portmap.
nat Commands
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20071119-0014 v1.0