Storage Device Cable Routing; Removing The Storage Tray - HP C160 Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices

Storage Device Cable Routing

When you install your storage device, be aware of the suggested cable rout-
ing paths as indicated in the cable routing label that is affixed to the top of
the storage tray.

Removing the Storage Tray

Perform the following procedure to remove the storage tray from the system
unit:
NOTE: To prevent injury, remove monitor from system unit before removing storage tray.
1 Remove the storage tray retaining screw, as shown in Figure 27.
2 If installed, remove any locking device from the storage tray security loop on the
3 Place your fingertips in the groove on the bottom of the storage tray bezel. See
Figure 27
4 Slide the storage tray completely out of the system unit.
108
rear of the system unit.
Figure 27.
Retaining Screw
Removing the Storage Tray