For HP Internal Use Only
Remove 3.5-inch Digital Data Storage (DDS) Device
1.
See Figure 8-5.
2. Disconnect the SCSI flat ribbon cable from the DDS.
3. Disconnect the power cable from the DDS.
4. See Figure 8-6.
5. Remove four TORX screws and remove the DDS from the front of the peripheral drawer.
Warning
Do not mix these screws with the system chassis screws or the disk support
screws. You will damage the DDS if you attempt to mount it with the system
chassis screws or the disk support screws.
8-14
Replaceable Parts