Preparing To Install Your Storage Device; Default Scsi Ids - HP C100/110 Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices

Preparing to Install Your Storage Device

This section describes information that you need to consider and procedures
that you need to perform before installing any storage device.
Configuring your Storage Device
Table 13 lists the recommended SCSI IDs for internal storage devices. If an
existing device already uses one of the suggested IDs, select an alternate ID.
Table 13

Default SCSI IDs

Set the jumpers and SCSI IDs according to the installation instructions that
came with your device.
Determining Your Storage Devices Position
Each storage device is restricted as to where in the storage tray it may be
installed. Before installing a storage device, use Figure 21 and Table 14 to
determine which disk tray position is correct for your device.
Figure 21 shows the storage device positions in the disk tray. Table 14 lists
what devices are supported in the different disk tray positions. The numbers
in the table's left column refer to the position numbers in Figure 21.
120
Fast/Wide Differential SCSI Devices
1st Hard Disk Drive
2nd Hard Disk Drive
3rd Hard Disk Drive
Single-Ended SCSI-2 Devices
CD-ROM Drive
DDS-Format Tape Drive
NOTE: The floppy drive is not a SCSI device.
SCSI ID
6
5
4
SCSI ID
2
3