Table of Contents
Advertisement
• Set Default Route to PPTP
Selecting Enable will route all IP traffic through the PPTP network. Selecting Disable will route only PPTP traffic
through the PPTP network.
• PPTP Server
The IP address of the virtual private network server on which to connect.
• Username
The username required by the VPN server.
• Password
The password, associated with the username, required by the VPN server.
PTPP Server Configuration
• PPTP Server
Selecting Enable starts the VPN server, and selecting Disable stops it.
• Server Local IP
The IP address that clients will use to communicate with the server after they connect.
• Client IP Range
The pool of IP addresses assigned to clients.
• Protocols Allowed
Selecting a protocol will instruct the VPN server to accept clients who use that protocol. The server will reject clients
using any of the un-selected protocols.
• Encryption
Selecting Use MPPE will enable Microsoft Point-to-Point Encryption for communication between the server and
clients. This option requires the MS-CHAP or MS-CHAPv2 protocol.
PPTP Server User Configuration
• Full Name
This name can be used as a more descriptive name for a client. It is not used by the server. No spaces are allowed in
the name.
• Username
The name used by a client to log in to the server.
• Password
The password, with associated username, used by a client to log in to the server.
3.6.3 IPSEC
IPsec serves to configure secured communication tunnels. The various tunnel configurations will be displayed in the
Tunnel Table at the bottom of the page. All tunnels are created using the ESP (Encapsulating Security Payload) protocol.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 56
Advertisement
Table of Contents
